Once you have determined the correct mixture, go ahead and fill the overflow tank up to the MAX line, as shown below. ![]() For cold climates, you can use a mix of 70% antifreeze and 30% distilled water. Note: If your anti-freeze is full strength, dilute it with 50% antifreeze, 50% distilled water. Here is a link to genuine Honda pre-mixed anti-freeze. If it says “pre-mixed,” then you don’t need to add any distilled water, you are good to go. Depending on the type of fluid you have, you may need to add some distilled water. You need to be a little bit careful at this point. Remove the cap on the overflow reservoir by unscrewing it and lifting it out. We just want to add antifreeze until it is up to the MAX line. In this case, the coolant level is between the marks, but a little on the low side. Here is a photo of the overflow tank showing the MIN and MAX lines. In addition to the radiator cap there is also a plastic ‘transparent’ overflow tank with a plastic cover. The radiator is at the front of the engine bay. The first step is to pop the hood and locate the radiator. ![]() Procedure to Add Coolant to a Honda Accord
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |